Emergency Water Calls, Any Hour
What happens in the first few hours shapes the whole job. Water wicks up drywall, swells particleboard subfloors, and soaks into carpet pad faster than most people expect. Within a day or two, a clean-water loss can turn into a mold job. That is why the phones are staffed all night and emergency calls go right to the closest contractor on duty.
An emergency visit normally begins with the crew confirming the source is off and the space is safe. They make sure the water is off, decide whether wet circuits need to be shut at the panel, and begin extraction with portable or truck-mounted gear. When there is standing water below grade, a submersible trash pump usually goes in before anything else. Next comes a round of moisture readings, a thermal imaging pass to map where water spread, and the initial set of air movers and LGR dehumidifiers.
When the first visit wraps up, a few things should be clear to you. You should know which rooms are affected, what water category you have, and what can be dried in place versus pulled out. You should also know when the contractor plans to return to take readings and adjust the equipment. Most homes need three to five days of drying, though hardwood, plaster, and stone foundations often take longer. Leave the equipment running, keep windows shut unless told otherwise, and keep the thermostat where the crew set it.
- Burst pipes, failed supply lines, and water heater leaks
- Storm water, roof leaks, and window well flooding
- Sump pump failures and basement seepage
- Nights, weekends, and holidays handled the same way




